Chicago Gaming

From PinWiki
Jump to navigation Jump to search
ExclamationPoint.jpg
Note: This page is a work in progress. Please help get it to a completed state by adding any useful information to it.


1 Introduction

Churchill Cabinet Company, who makes cabinets and playfields for other pinball manufacturers, decided to venture into making their own pinball machine. These machines were made strictly for the home market under the name of Chicago Gaming Company.

2 Games

  • Vacation America, December 2004, model 9000.

3 Technical Info

Owner's Manual and schematics for Vacation America home model pinball. File:Vacation America manual.pdf


Dimensions: 74" high by 53" long by 25.5" wide. Weight: 200 pounds

4 Problems and Solutions

4.1 Power Problems

The power transformer, power supply board, and fuses are all located on the bottom floor of the machine. There are four fuses on the power supply board:

  • F1 8 amp slow blow for the +45 volts to flippers
  • F2 5 amp slow blow for the +24 volts
  • F3 5 amp slow blow for the +38 volts to coils
  • F4 3 amp slow blow for the +12 volts

There are a total of seven power indicating LED's on the power supply board:

  • D1 indicates +45 volts present
  • D2 indicates +24 volts present
  • D3 indicates +38 volts present
  • D4 indicates +12 volts unregulated present
  • D5 indicates +5 volts present
  • D6 indicates +12 volts regulated present
  • D7 indicates -12 volts present

Bridge rectifiers.

  • BR1 GBPC25-02, 25 amp 200 volt, is for the +38 volt coils
  • BR2 GBPC25-02, 25 amp 200 volt, is for the +24 volt circuit
  • BR3 GBPC25-02, 25 amp 200 volt, is for the +45 volts to the flipper coils

Electrolytic filter capacitors.

  • C1 10,000 uf @ 50 volts snap mount is the filter for the +38 volt coils
  • C2 10,000 uf @ 35 volts snap mount is the filter for the +24 volt circuit
  • C3 10,000 uf @ 50 volts snap mount is the filter for the +45 volts to the flipper coils

4.2 Solenoid Problems

4.3 Lamp Problems

4.4 Switch Problems

4.5 Display Problems

4.6 Sound Problems

4.7 Flipper Problems

The flippers operate on 45 to 50 volts DC from the power supply board. They are modern Stern units with normally open end-of-stroke switches. Flippers are driven from driver transistors.

Driver transistors:

  • Q110 Right Flipper "Flip", type IRFZ34
  • Q111 Right Flipper "Hold", type IRFZ34
  • Q18 Left Flipper "Flip", type IRFZ34
  • Q112 Left Flipper "Hold", type IRFZ34 (Note: mistake in schematic calls this right flipper hold)

4.8 Pop Bumper Problems

4.9 Slingshot Problems

4.10 Opto Problems

The optos operate on +12 volts. If the +12 volts is bad or missing, none of the opto switches will work.

5 Repair Logs