Talk:Bally/Stern

From PinWiki
Revision as of 13:23, 16 October 2013 by Bdols (talk | contribs)
Jump to navigation Jump to search

re: Diodes on bally stern - I think you should revert it back, there's no more investigation needed. Bally used it from the factory. Stern used it interchangeably. While I usually put 1n4004's back on because I have a ton of them due to their universal use in wpc etc. and on coils, the issue raised by the RGP discussion of this is completely wrong..... you're not pumping more than 5 volts through it (the PIA is driving it) and you're not putting more than 0.2 amps through it, either. I forget the spec offhand for the PIA's max current output capability, but I doubt it's getting anywhere near 0.2 amp, and there's current limiting resistors on the mpu board anyway on the strobes and returns.

Also, not sure that changing pinwiki to mirror what some random chatter on RGP speculates on is a good idea. You're taking the authoritative source (the machines themselves, and the documentation provided with them) and changing it to suit the opinions (dead wrong, in this case) of a couple individuals who either didn't think through what they were posting or flat out don't understand ratings of parts. You could just as easily sub a 1n4001, 4002, 4003, 4005, 4006, 4007 diode across the switch matrix and it will work fine in this applicaiton. Ditto with other small signal diodes (although I have not seen the 914 specified in bally or stern's documentation).

re: Diodes - SC, it was not a knee jerk reaction to a discussion on RGP. It was a matter of observing the discussion, and then referring to the Stern and Bally documentation. Both Bally and Stern consistently state "1N4004 diodes are used". There were no statements in the docs regarding 1N4148s. Now, if you've physically seen 1N4148s (you are much closer to this era of games than I), then that's a different story. On a similar note, it has been recommended to use 1n4004s on GTB sys1 and sys80 games. GTB explicitly states ion docs that 1n270s can only be used on their games. That was the kind of info I was looking for from Stern or Bally in their docs. - jpal