Difference between revisions of "Other Than Pinball Games"
Jump to navigation
Jump to search
| Line 3: | Line 3: | ||
== Motor Replacement == | == Motor Replacement == | ||
| − | [[File:ICBOEMMotor.jpg|200px|thumb|left| | + | [[File:ICBOEMMotor.jpg|200px|thumb|left|The OEM Motor, showing the gear to be removed.]] |
| − | [[File:ICBReplacementMotorToInstall.jpg|200px|thumb|left| | + | [[File:ICBReplacementMotorToInstall.jpg|200px|thumb|left|The replacement motor to be installed.]]<br> |
| − | [[File:ICBOEMMotorBracket.jpg|200px|thumb|left| | + | [[File:ICBOEMMotorBracket.jpg|200px|thumb|left|The OEM bracket, showing 4 motor attach points.]]<br> |
| − | [[File:ICBHackMotorShaft.jpg|200px|thumb|left| | + | [[File:ICBHackMotorShaft.jpg|200px|thumb|left|Use a hack saw to cut the shaft of the original motor.]]<br> |
| − | [[File:ICBPunchGear.jpg|200px|thumb|left| | + | [[File:ICBPunchGear.jpg|200px|thumb|left|Position the shaft/gear in a vice but don't tighten the vice on the shaft. Punch out the old shaft.]]<br> |
| − | [[File:ICBInstallGear.jpg|200px|thumb|left| | + | [[File:ICBInstallGear.jpg|200px|thumb|left|With the "tail" of the new motor shaft on a solid surface, gently tap the original gear onto the new motor shaft.]]<br> |
| − | [[File:ICBNewGearInstalled.jpg|200px|thumb|left| | + | [[File:ICBNewGearInstalled.jpg|200px|thumb|left|The original gear, installed on the new motor shaft. Note that the shaft doesn't quite come to the gear edge.]]<br> |
| − | [[File:ICBBracketMod.jpg|200px|thumb|left| | + | [[File:ICBBracketMod.jpg|200px|thumb|left|Enlarge the hole in the original bracket to 13mm. Here a 1/2" drill bit is used to remove most of the material...]]<br> |
| − | [[File:ICBHoleEnlarge.jpg|200px|thumb|left| | + | [[File:ICBHoleEnlarge.jpg|200px|thumb|left|...and then a rat tail file is used to complete the enlargement.]]<br> |
| − | [[File:ICBModifiedBracketInstalled.jpg|200px|thumb|left| | + | [[File:ICBModifiedBracketInstalled.jpg|200px|thumb|left|The original bracket, deburred, and installed on the new motor. Two screws are sufficient to hold the motor in place.]]<br> |
| − | [[File: | + | [[File:ICBReplacementMotorGearInstalledView.jpg|200px|thumb|left|A view of the new motor and original gear, perfectly aligned with the motor gearbox.]]<br> |
| − | [[File: | + | [[File:INewMotor.jpg|200px|thumb|left|The new motor, in place.]]<br> |
Revision as of 21:39, 1 September 2015
1 Taito Ice Cold Beer
1.1 Motor Replacement
