Other Than Pinball Games

From PinWiki
Jump to navigation Jump to search

1 Taito Ice Cold Beer

1.1 PinSide ICB Owners Thread

A very lengthy thread regarding the Taito ICB model can be found here.

1.2 Florescent Lamp

The original playfield lamp is an F15T12. The fluorescent light degrades the paint on the backglass. The florescent tube can be replaced with a modern LED, such as TBD.

1.3 Taito Service Tips

1
2
3
4


1.4 Diagnostics

YT.png A video demonstrating MPU diagnostics can be found here.

1.5 Connector Pin-out

1.6 Motor Replacement

Replacement motors for Ice Cold Beer were available from Twisty Arcade a few years ago. The installation procedure for this motor, or an equivalent can be found below. The principle part of the job is to transfer the gear from the old motor shaft to the new motor shaft, and modify the motor bracket to mate to the new motor.

The motor from Twisty Arcade came with a 6.2ohm, 5W resistor. It may be necessary to replace this part with a 10ohm, 5W resistor to slow the motor a bit more. If your game raises the bar too far to "serve" the ball, install a replacement resistor of perhaps 8.2ohm, 5W, or even the 10ohm part.